You want to tip the engine slightly to ensure that all of the oil is drained. Do this slowly, as oil will start pouring into the bowl.
Drain the Oil Out – Remove the M6 bolt with a suitable socket. Locate the Oil Drain Plug – As you can see from the images above, the oil drain plug is located underneath the dipstick. Place a Bowl or Drain Pan Underneath – Now, place an empty bowl or drain pan underneath the engine (it should be underneath the oil drain plug, so it can collect the oil. Make sure the engine is looking out slightly so that the oil can drip down. Place Engine on Table – When draining the oil, ensure that the Predator engine is off and place it on a table (a floor won’t work). To drain the oil out of a Predator 212 engine, you’ll need a 10mm (M6) socket or torque wrench and a bowl or drain pan to collect the oil. Excess engine oil may cause it to leak due to excess pressure. If you’re changing your oil or topping up too much oil, you need to drain it. #Predator 212 iguard full#
After you’ve topped it up, make sure that the oil levels are full as this will ensure your engine runs optimally.
At the step before you insert the dipstick back into the engine, top it up with your preferred engine oil. To fill oil into the engine follow the steps above on checking oil levels.
If your Predator 212 doesn’t have enough oil, you may see smoke emitting from the engine, as it lacks proper lubrication and internal components heat up. You’ll always need to make sure that you run your engine with enough engine oil. If you need to fill oil into the engine, go to the next step. There is no need to clean the dipstick this time, before inserting it.
Reinsert the Dipstick – If there is no need to top the oil up, then you can proceed to thread the dipstick by turning it clockwise. Now check the reading and compare it with the oil level markings in the illustration above. Check Oil Level – To check the oil level, simply reinsert the dipstick without threading it – it should only touch the bottom of the dipstick thread. Use a cloth to clean the oil off it, as you’ll need to get an accurate reading. Clean the Dipstick – Now unscrew the dipstick by turning it counterclockwise. 
Close the Fuel Valve – Close the fuel valve, which is a lever that is located right underneath the choke. You can identify the dipstick by the yellow cover (use the image above for reference. Locate the Dipstick – The dipstick is located on the side where the pull start handle is facing. Ensure Engine is Off – Make sure that when you check the oil level, the engine is completely shut down and is placed on level ground – on a table or floor would be optimal). Follow the guide below for more information. All you need to do is use the dipstick to see what the oil level inside the engine is. Checking Oil LevelsĬhecking the oil level on your Predator 212 is simple and straightforward. My preferred engine oil is the STP 4-Cycle 10W-30 Engine Oil, as it’s optimized for 4-stroke small engines like the Predator 212. So, what’s the best engine oil for the Predator 212? Well, there is a wide selection of engine oils in the market and any 10W-30 oil that is high-grade will do. 
Therefore, in most cases, a 10W-30 engine oil would work just fine. Check the section below for the best engine oils! Best Engine Oils For Predator 212 If the outside temperature is below 32° F, a 5W-30 oil is going to be more suitable, as suggested by the manufacturer. Predator 212 engines take 10W-30 oil if the outside temperature is 32° F (0° Celsius) or above.
0 kommentar(er)
